DIY: Univibe+ Kit PCB

Satisfying die-hard Vibe fans many years later: the original (c)1996 “split-rail/regulated-audio” Univibe cloning kit // Copied by others but unsurpassed in performance thanks to an original Bulb-Bias Offset Mod. The PCB Kit includes a membership to the VA-works forum where all circuit extensions, including a new controller board, and mods live. $30CDN



3 comments on “DIY: Univibe+ Kit PCB
  1. stuart says:

    Hi JC , I live in the UK , are you still selling your uni-vibe PCB.

  2. jcm says:

    HI STUART … YES I am, I SHOULD PUT A PURCHASE PAGE BACK UP // BACK TO YOU SHORTLY … THX FOR ASKING

  3. jcm says:

    HI STUART, YES I STILL HAVE VIBE PCB’S … IF YOU’RE NOT IN A RUSH EMAIL ME AND I’LL DIG THEM UP

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.

360+ Pro Fuzz/Preamp

360+ProButton

360+ DIY Kit

360+diyKitButton

Mu3 DIY Kit

360+ProButton

IFMTA (book)

FWboard-Button

IFMTA (PDF)

FWboard-Button

Champ (PDF)

uChampButton